KT-QD01 Benchtop Pneumatic Dot Peen Marking Machine Metal Engraving 150*130 Marking Area for Nameplate, Logo, Serial Number PrintingThe dot peen marking machine is perfectly suited for use with a variety of industrial products with higher efficiency and convenience.Model: KT-QD01Inputting air pressure: 0.3-0.6MPaMarking depth: 0.01 ~ 2mm (depends on the different materials)Marking contents: Characters, alphanumeric, date, numbers, serial No, VIN code etc.Direct Part Marking (DPM) – This is a process of permanently marking parts with a barcode. This is done to allow the tracking of parts through the full life cycle.Fitting/tube/pipe circle markingScale engraving markingNameplates markingMetal parts marking (Stainless steel, brass, aluminum, copper, titanium etc.)Component identificationComponent traceabilityLot numberingNameplate markingCast and Forge MarkingRod, engine markingGear, pump markingBowl markingPart or Equipment numberingBatch & Shift CodingTools markingVarious Metal Label MarkingPneumatic Marking Machine made of high-hardness tungsten alloy, the hardness of marking needle can reach 60HRC, mark deeper with better effect than the electric marking machine. The pneumatic dot peen nameplate marking machine adopts WINDOWS operating system (Windows XP / 7/8/10 32bit/64bit), with a friendly interface & simple operation. The pneumatic machine can be used to mark codes, English letters, logos, graphics, serial numbers, VIN codes, on metal engraving and stamping plates.SpecificationsVoltage: AC220V Marking Area: 150 x 130 mm Marking Type: Automation Gross Weight:38 Kg(83.7lbs) Package Size:43 x 47 x 84 cm/16.9 x 18.5 x 33 inch