Need 6V 1.5V cell or 4.8V with 1.2V cell to run a project on AA batteries? This is a simple battery holder that we use in some of our kits. What we like about these are the leads that come pre-attached, ready to be soldered to a PCB, or attached with your choice of connector.
Two mounting holes to accept flush head screws. You can also use high adhesive double sided tape, or a glue gun to attach to your project or prototype.
Simple 4 Cell AA Battery holder square
This battery holder have two wires 6 inch of 24-gauge leads that have 5 mm of insulation stripped off of the ends